The manufacturer of IK10 inground light tells you that underground lights are widely used in our daily lives. We often see underground lights used in tourist attractions. The decoration effect is very good. The volume of the underground lights is very small and the heat dissipation is very good. The ultra-high brightness light source is a new type of lamp. The long service life is the most obvious feature of the underground lamp. But what should be paid attention to when designing the underground lamp?

The manufacturer of IK10 inground light tells you that inground lights need to be very careful about lighting effects and waterproof problems. Inground lights started from control changes at the beginning, but now few people are willing to do the light project. , The reason why no one is willing to do the underground lamp project is that there are many design problems in the underground lamp, so the service life of the underground lamp is not too long, so now people are not willing to do the underground lamp. light.
The IK10 inground light manufacturer tells you that the power supply of the underground light is different from that of the ordinary light, so if the design is not handled well, the life of the underground light will not be longer than that of the ordinary light. The IK10 inground light manufacturer tells you that because the underground light is buried underground, it is sometimes more difficult to solve than the light in the water. This is the design difficulty of the underground light.
The IK10 inground light manufacturer tells you that the design of the underground light is the first choice of the housing. Many underground lights use aluminum housing, which is actually not conducive to the work of the underground light, because the characteristics of the aluminum housing are easy to make Water penetrates in, so it is very bad to use aluminum on the shell of the underground lamp. It is best to use stainless steel for the shell of the underground lamp.
The IK10 inground light manufacturer tells you that the design of the cable hole is also very important for the underground lamp. The underground lamp is used as a lighting fixture on the ground. It is not only the problem of water release, but also thermal expansion and contraction. Wait for the situation. The manufacturer of IK10 inground light tells you that it is best to use the v-shaped rubber ring for the cable hole in the v-shaped hole. This v-shaped rubber ring can not only prevent water from penetrating through the rubber ring, but also prevent water from penetrating along the thread skin. In addition to using the V-shaped rubber ring for the cable hole, the cable hole can also be filled with epoxy resin, but this method is very troublesome in the future maintenance of the buried lamp.
The IK10 inground light manufacturer tells you that the heat dissipation of the buried lamp is very critical, because the light source board of the buried lamp is overhead. If the power is still very large, it is easy to make the heat of the buried lamp not be able to dissipate in time, causing The service life of the lamp is not long. The manufacturer of IK10 inground light tells you that the buried light is transmitted to the housing through the air, and then transmitted to the ground through the housing. Therefore, in our design, it is best to make the contact area between the shell and the ground reach more than 80%, so that the underground lamp can have good heat dissipation.
The above are the precautions for the design of the underground lamp. The specific design situation should be judged according to the specific use of the underground lamp, so that the designed underground lamp can achieve high usability and long life.