3W integral LED inground light is a new product that is buried on the ground as a landscape decorative lighting. The fashionable LED is made of die-cast aluminum spraying and stainless steel panel. 3W integral LED inground light has super compression resistance, screws and panels are made of stainless steel, which makes it have good waterproof, dustproof and corrosion resistance. Its waterproof level reaches IP67.

1. Before installing the 3W integral LED inground light, you should prepare an IP67 or IP68 wiring device for connecting the external power input to the power line of the light body. Moreover, the power cord of the 3W integral LED inground light requires a waterproof power cord to ensure its service life.
2. The sealing of the wire connection should be done well: Generally, the wiring port of our buried lamp has a special sealing rubber ring and stainless steel fasteners. First, pass the wires (specially pay attention to the three-wire cable) through the rubber ring, and then put the stainless steel fasteners. Tighten until the wires cannot pull out of the sealing rubber.
3. Before installing the 3W integral LED inground light, the power must be cut off. This is the basis for the safe operation of all electrical equipment.
4. Before installing the 3W integral LED inground light, you should sort out the various parts used for the lamp. It is a special landscape LED lamp that is buried in the ground. It is very troublesome to re-install once the parts are missing during installation. So it should be ready before installation.
5. Before installing the 3W integral LED inground light, a hole should be dug according to the size of the embedded part, and then the embedded part should be fixed with concrete. The embedded parts play the role of isolating the main body and the soil, which can ensure the service life.